Used Nissan X-Trail Handbrake Cable
Get quotes for a used or replacement Nissan X-Trail handbrake cable. Genuine second hand parts from UK vehicle dismantlers - free request, breakers with stock reply direct.
Enter your registration or select your vehicle
Find the right part faster and get quotes direct from UK breakers - free, and no obligation.
A buyer's guide to used Nissan X-Trail handbrake cable
No two handbrake cables are quite the same across different vehicles, so getting the specifics right matters when you buy used, second hand or a replacement. Answer a few quick questions below and breakers will only quote if they have the exact matching part in stock:
- State whether it's left or right
Other used Nissan X-Trail parts
- Used Nissan X-Trail Wishbone
- Used Nissan X-Trail Suspension Leg
- Used Nissan X-Trail Propshaft
- Used Nissan X-Trail Subframe
- Used Nissan X-Trail Rear Tailgate
- Used Nissan X-Trail Heater Matrix
- Used Nissan X-Trail Brake Pedal
- Used Nissan X-Trail Tyre
- Used Nissan X-Trail Cylinder Head
- Used Nissan X-Trail Door Card
- Used Nissan X-Trail Rear Bumper
- Used Nissan X-Trail Wing
Used handbrake cable for other Nissan models
Fitment questions
Does the Nissan X-Trail have a traditional handbrake cable?
The X-Trail T32 (2014 onwards) uses an electric parking brake, so there is no handbrake cable on that generation at all. The earlier T30 (2001–2007) and T31 (2007–2014) generations do use a conventional mechanical handbrake with a cable, so if your X-Trail is from either of those generations you are in the right place. If you have a T32, the part you are likely looking for is an electric parking brake actuator or motor, not a cable.
Will a handbrake cable from a 2005 X-Trail fit my 2009 X-Trail?
These are two different generations — the 2005 car is a T30 (2001–2007) and the 2009 car is a T31 (2007–2014) — and the cables are not the same. You should source a cable that matches your specific generation; confirm the exact part against your registration with the breaker before buying. Do not assume a T30 cable will transfer across the generation boundary.
Does engine size affect which handbrake cable I need on the X-Trail T31?
On the T30 and T31 X-Trail, brake and cable specifications can vary with engine size, as larger-engined variants may run uprated brakes, so the 2.5-litre petrol and the 2.0 or 2.2 diesel variants are worth distinguishing when speaking to the breaker. Always confirm the cable against your registration number so the breaker can match the correct specification to your vehicle.
Does my X-Trail's trim level — Visia, Acenta, or Tekna — affect which handbrake cable I need?
Trim level does not affect handbrake cable fitment on the X-Trail — the cable is part of the running gear, not the trim, so a Visia, Acenta, or Tekna on the same generation and with the same engine will use the same cable. You may find minor cosmetic differences on parts pulled from higher-spec cars, but these have no bearing on fitment. Generation and engine size are the details that matter.
I have a 2013 X-Trail — is this a T31 or T32, and does it affect which cable I need?
A 2013 X-Trail is a T31 (2007–2014), so it does have a conventional handbrake cable — the T32 with its electric parking brake did not arrive until 2014. Source a cable specified for the T31 and confirm the engine variant with the breaker against your registration to ensure an accurate match.
Can I use a rear handbrake cable from a right-hand side on the left-hand side of my X-Trail?
No — the NS (nearside, left) and OS (offside, right) rear handbrake cables on the X-Trail are handed and are not interchangeable, as they are different lengths routed to opposite sides of the vehicle. When contacting a breaker, make sure you specify NS or OS clearly so they can pull the correct cable from the donor vehicle.